I have a similar problem as above. I have paired my Brel bidirectional blinds via RFXmngr, so I can sends commands from there, but if I want to add a manual switch to Domoticz, I see various types/brands of blinds, but I do not see the Brel DDxxx type. BTW, I am running Domoticz 2023.2 (build 15457 ...

The only line I see in this article which mentions a mount point is this one: /etc/localtime

I have a similar problem. Since two weeks I am running Domoticz in Qnap Container Station. I get the following error: Error: EventSystem: problem writing file: /opt/domoticz/userdata/scripts/dzVents/generated_scripts/Hue syncen met Domoticz.lua Any idea how I should solve this? Also, I am struggling ...

As some people seem to have less issues with Z-wave, are you guys running the latest offical Domoticz version 2020.2.11995 or a newer beta version?

As I wrote before, in 4.1017.. with zwave 1.4 it works (I went back some months ago). When I reboot, the zwave-devices are there after some seconds. There seems to be the difference to 1.6 and seems to cause the problems in 1.6. I have a similar experience. 4.1017 hardly gives any issues. After ...

@sieth: I also thought about abandoning Z-wave an move to Xiaomi sensors. Are you still using Domoticz? What Zigbee gateway do you use?

The problems in this topic all sound so familiair. I moved from a RPi to running Domoticz on a Qnap NAS. Domoticz Version 10.717 runs stable and after a reboot all z-wave devices are recognized within minutes. Running 2020.2.1195 is terrible. Just can’t get the z-wave devices stable. Switched back t ...

@SweetPants: Good suggestion. Will do.
Not sure though how to delete this one....

I was on vacation for the last week and after three days on my destination I was not able to get remote access to Domoticz anymore. I also use the Pilot App which could also not get in touch with my Pi running Domoticz. By using the IP camera software I could see that all scripts and timers were ...

True. As an alternative I have written a script which turns on the light if the wall switch is pressed, but this solution is a bit slow. As the devices are all in the same room I think the direct connection by using association would be the best solution but sofar I have not been able to get it to ...

Thanks for the tip. I checked both values, but they are as you specified: Parameter 36 has value 255 and Parameter 37 is set to 0. These are the default values and I never touched them.

I have three Fibaro FGS-223 double swithces in my bedroom. If I press the second switch on the wall (Node:034) I want the first Switch of Node 036 to also switch on. In the Fibaro manual I see that Group 4 is the group connected to the second switch. My conclusion was that I should add 36 to Group 4 ...