Exactly. But it's sometimes hard to find ;). Including 2 times the same device without excluding it before was not obvious. Neither the manual association. You've found some informations that lead to this process or it was just a (good) feeling ? Thanks also to ben92 for its support too ;). Have a ...

Marvellous. :D It works. Thanks a lot fpatou. I hadn't do step 1 (not able to deleted my very few unsued devices such as old motherboard sensors, this kfob is my first OZW device). For step 3, I try using "Group & Network" from my Zwave Controller and set node 1 to each group and then apply ...

Exactly the same. Not better with a new battery...

Hello fpatou, Thanks for not giving up :). I hope you're near the truth by pointing out battery issue. Have you seen this post ? https://www.domoticz.com/forum/viewtopic.php?f=6&t=3746&start=20 It seems that bjoern have exactly the same issue as us. The solution seems to be too simple : change the ...

Thanks for your reply ben92. I'll try tonight, but I'm pretty sure that I've already done this step and no particular log appears in Domoticz "log part" (neither in the Open Zwave log : OZW_Log.txt). Perharps we have issue about our drivers (controller ? the kfob ? kfob firmware ?). That's could ...

You're right fpatou, there are some minor changes for the configuration of a ZME_KFOB-S version. I join the config I've set in accordance with ben92 advices for a ZME_KFOB. Config Kfob S.JPG Config Kfob S 2.JPG For ben92, I'm sorry to be so noob, but when and/or where (on which screen) should I have ...

Hello ben92 and tophattaylor, I'm pretty new on Domoticz (buy my Zwave USB Stick and first Zwave module last week) and I'm exactly in the case of the last post of tophattaylor. I've read and searched some hours to be able to add a device in a scene in domoticz with a Z-Wave.Me ZME_KFOB-S 4 Button ...