The problem is that with the p1 gasmeter you have to add the usage with the stored usage and write the total in then pp1 meter with updateGas.
The issue is that I don't know how to get the stored value out of the P1 meter into a local value in dzVents.
I now changed to a standard incrementele ...

Hi,

I created a virtual P1 meter where i want to store the gas usage by using hot water from the central heating system.

I count the numbers of minutes the system delivers hot water and i found out that one minute hot water usage average 50 liters of gas. When the hot water is shutdown a scripts ...

Fixed in build 16929

Hi,

Like I wrote earlier I'm not zo familiar with zigbee2mqtt so I don't no what the AD Config Message is and where to find. I googled AD Config message so hopefully this is where you're looking for to help me.

{
"action_template": "{% set values = {None:None,'idle':'idle','heat':'heating','cool ...

What you described above is what I also see in MQTT Explorer.

The running_state is what shows if the heater is really on, the system_mode sets if the heater is swithed on when local temperature is below setpoint.

The running_state is recently added to domoticz. I found a topic which mentioned an ...

Hi,

I use a Tuya ZWT198/ZWT100-BH thermostate and for zigbee it uses TS0601 model

I want to use the value running_state' to act on idle of heat. The payload gives 'idle' of 'heat', while Domoticz expects 'idle' or 'heating' . This mismatch logs a error in the domoticz logfile
Error: mqtt: Climate ...

Hi,

I ran into this problem

Last login: Fri Jan 3 23:01:18 2025 from 192.168.1.107
pi@domo-spion:~ $ sudo bash -c "$(curl -sSfL https://install.domoticz.com)"
curl: (22) The requested URL returned error: 403
pi@domo-spion:~ $

Earlier on that evening i succeed an installaties. I noticed that ...