Don't know where you live but yes, thats what I tried with a colleague to rule out errors on my side first.

Hi Ruud. It seems if you have bad cdma network the metet stops sending looks like buffer full. I had mine be replaced by an older type that does 2g gsm or so.
The Reset I did by switching off mainpower before the meter. But as I understand this is not always possible.

Hello, Yesterday I saw in Domoticz that the P1 port of the ISKRA AM550 smart meter was not sending data anymore. I had this before and had the smart meter replaced by the company. Now it was after another 5 months (the previous one lasted 7 months) so this got me thinking. Thinking about another ...

Hello, If I make a blockly and I set it up to do some checks and after these checks a switch is set to OFF AFTER 10 minutes. Then some outside events happen and I don't want the switch to go off anymore. How do I tell this to Domoticz? I have seen the "STOP" in the SET block, but I cannot find ...

I will like to add that I have a switch in the kitchen for setting the speed. The ComfoFanS does take the highest speed requested as the one to work on. This means that I can "override" the 0-10V with the 220V switch. Very convenient to be able to use both.

Does power off/on of the node and then restarting domoticz not work for you? Sometimes they fail here too. They are not super stable. It looks like when something goes wrong in transmission they fail.

Look into the manual.
What you have encountered is probably the reset procedure of the sensor.

When you just replace the battery with the magnet intact it will just be fine.

Just tested it to do a reboot of the sensor, because it was not sending temperature anymore. That worked without issues.