I would like someone using mqtt to be able to test its proper functioning by communicating with a virtual smart meter and see what is the result of the power graph in its log, I think I tested everything I could, and the graph is not displayed correctly but just from version 2024.6 and up including ...

I will do that thank´s

I just remove the divisor value from the energy counters in the domoticz setup, that's enough for me. This is just a test setup, I didn't even bother changing the parameters every time I cleaned the installation and reinstalled it several times until I came to the conclusion that only versions 2024 ...

I made sure and from Esp that the power and total Kwh counter do not have decimal places, and this is confirmed by the message received in domoticz/in {"command":"udevice","idx":1,"svalue" :"36519;10;2174;20;1545;100"}

Thanks for all the help.

Screenshot 2024-11-05 at 20-35-18 Energia.png

And looking to the widget showing a factor 1000 higher Watt value than in the graph I still believe you have a javascript issue.
The webbrowser for the new Domoticz is using the old javascript....


I just tested it on another machine where I never opened this domoticz server, I updated Firefox ...

waltervl wrote: Tuesday 05 November 2024 19:16 Are you sending only once per half hour a message or more messages? As it looks you only send a message approx every 30 minutes.

Esp sends a new message every 5s (five seconds)

"Perhaps play a bit with the "P1 Electricity report display setting" as shown in wiki page:
https://www.domoticz.com/wiki/Applicati ... alculation" ------I already did this and didn't get any improvement.

"Are there commas or dots in the values coming from ESP as it seems the high values Watt are ...

Thanks
The "[mem#kwh]" this is the return counter ,this is a variable in espeasy coming from another esp8266 module with a pzm004T that monitors my solar production and transmits the values ​​via espeasy P2P network and so I can integrate all the values ​​in the same message, today there is no sun ...

Thanks
I believe that if it were a bug there would already be someone else complaining, I use an ESP8266/PZM004T with espeasy software and this rule, Publish domoticz/in,'{"command":"udevice", "idx":1, "svalue":"[PZEM#Energy_kWH];10;[mem#kwh];20;[PZEM#Power_W];100"}'

On mqtt explorer i have this ...

Hello
First of all, thank you for developing Domoticz, I have been using Domoticz for about three years, I recently did a hardware upgrade and with this I installed the latest version of Domoticz on Windows (2024.7) from this day on my Virtual smart meter does not show the correct values ​​in the ...

Tank you that´s a good idea, but Domoticz requires one notification Active Systems to be checked, if you uncheck all Active Systems,
and click update Domoticz activates all Active Systems, i cleared my browser cache but the behavior is the same.
So i left one notification Active Systems checked, it ...

Hello I added some Esp 8266 board´s to my old electric heaters and brought them back to the 21st century with centralized control from Domoticz, now spring has arrived and it's time to put them away in the pantry, I created a notification on each one of them, case one goes offline or overheat I get ...