Me and my father decided to make a testboard again and I think I have done something wrong in the first place, because after resetting the Q (5 times) it finally included and is seen in my Domoticz environment.

It is a test setup with only a light, but I will try to get the light running first ...

The 24 volt setup is about 10 meters away, but with a double brick wall in between. Does it matter when you include the Qubino, while taking the Z-stick next to it?

My 220v setup was in the same room.

1. Might be a dumb question but are you sure both ZStick and Qubino are 868 MHz Europe version?\

I checked it. That's the case.

2. Hard reset the Zstick.

I did. Did not changed anything. The Z-stick does show up in my Domoticz again.

3. Press the ZStick button for 3 seconds and make sure ...

So I checked today if my acceptance was enables. That is the case.

See picture: https://imgur.com/a/WUKOnOv

I also tried to add in manually with the 24volt option (with the S service button). No succes unfortunately.

My Z-stick does show in the hardware section.

These are my only two devices so far.

I thought the checkbox is enabled, but will going to check that one this evening.

And about the inclusion:
- I don’t have a push button installed, so it is hard to use it that way. Do you think it is mandatory to install a push button?
- the second one ...

Dear people,

I wanted to try the world of Domoticz, because for the first time I really felt a need for it. Namely to start automating the garagedoor.

To do this I purchased:
- Raspberry pi 2 (already had one)
- Installed Domoticz (went and works fine)
- Aeon Z-Stick USB 5 gen
- Relais Z-Wave ...