Hi CV8R!!

You have done a very good job!!! Plugin works perfectly.
I'm trying to find any error but no one found

I will make a change in temperature selector, when fan is active could show temp "Off"

Regards

Hi All, I am in no way a programmer but took the risk and bought a IntesisBox PA-RC2-WMP-1 which is matched to my Panasonic whole home inverter in the hope of getting a plugin working and learning something along the way. The PA-AC-RC2-WMP-1 uses the WMP protocol and I am sure the WMP protocol is ...

Hello,

I have been in contact recently with Intesis, and unfortunaly they only share the API with enterprises (previous project). Domestic developers are out of this policy and can't access to API.

Regards,

Hello, Has anyone dedicated time to integrate IntesisBox/IntesisHome with Domoticz? I have seen that there are some drivers for some home automation platforms ( https://www.intesisbox.com/en/fujitsu-ascii-wifi-vrf-fj-rc-wmp-1/gateway/ ) I have installed recently a Fujitsu duct air conditioner and I ...

I have the same problem. Six bulbs that I need to reconect to Zigate.
After Zigate firmware upgrade I need to reconnect the six bulbs, but I can't do a factory reset of the bulbs. Switching on/off few times didn,t work.

Great!!!
All working fine again!

Thanks Pipiche, great as usual

Sorry, only fail with 2 switches. I deleted these 2 switches in Domoticz and when I join them to Zigate do not appear in Domoticz again. They appear in DeviceList-xx.txt, but not in Domoticz. When I push the switch this is the message in log: 2019-03-07 20:39:07.515 (ZiGate) ZigateRead - decoded ...

Well... All devices paired fine, except Aqara Wireless Switches (single and double). I can't join them with Zigate.

Hi,

Yesterday I made a erase PDM and software reset. After this Zigate started blinking again. I have to chek if I can pair again with devices...
I'll maintain you informed

I have already done a Software Reset, but I haven't done a Erase PDM. I have a lot of devices conected and I would prefer not to reconnect all of them.
But if it is mandatory...

Hi all, I have the same problem as described in https://github.com/sasu-drooz/Domoticz-Zigate/issues/249 after upgrading Zigate firmware to 3.0f. After this I have tried to update zigate plugin (checked stable, beta and pre-4.1 branches), upgraded raspbian to strech to have pyhton3.5, upgraded ...