Hi bbqkees, I get no output with the lines below. My output: New datagram found with Sender ID: Receiver ID: New datagram found with Sender ID: Receiver ID: Where exactly do I need to add the extra lines? kapav, You can add something like the following code to see which datagrams appear on the bus ...

Sadly I am also having the issues sijones described. No fix at the moment? I sent it back as faulty and won't buy the TKB stuff anymore as i think their firmware might be rubbish... Fibaro stuff seems much better. My lamp would sometimes flicker, together with the problem above I decided to send to ...

I managed to get it working. I shut down Domoticz, put the Z-stick in exclude mode and pressed the button once on the dimmer. I than plugged the Z-stick back in the Pi and booted it again, in Domoticz I put the Z-stick in include mode and pressed the button on the dimmer again. It got recognize and ...

Hi, how did you manage to include the TKB dimmer into the network? Mine won't pair.

I'm using a Aeon Z-stick gen5.

Hi,

I'm trying to get your url's to work, but I always receive "status" : "ERR". Do I need to use the nodeID as the IDX?

When I manually set parameter 72 in the node settings, I am able to activate the effects.

Domoticz v2.3530 with Z-stick Gen5

gertjuhh wrote:When having a time span over midnight use OR instead of AND (for time time part obviously)

That did the trick. Thanks!

Hi, I'm trying to create a blockly script which detects if my server is down. With Lua a ping is performed every minute, when it's a succes it's switches "DUM Ping" on. If it's a fail, it's switches "DUM Ping" off. The Lua part works perfectly. The blockly part however won't start and it has to do ...

Nice! It works.

Thanks again and keep up the good work.

With the rollertroll, if you press down, and then down again, it stops? No it doesn't stop, it just keeps on going down. Same for the up direction. Or does it needs an actual 'real' stop command? (I mean, in RFXMngr appplication, is there a special stop command?) Here are the commands I could get ...

Hi guys, the RollerTrol came in this week. I installed it yesterday and it's awesome! Works perfectly. I learned the device to Domoticz with the 1 channel remote also from RollerTrol. To do this I needed to set the mode of the RFXtrx433 to Blinds T0 . Like said before, all other protocols are ...

b_weijenberg wrote:Note that you do not need to enable any protocol in the RFXtrx433 for transmit. All protocols are always enabled for transmit.

Thank God! The RollerTrol has been ordered!

Hi!

I'm gonna buy a rollertrol for my projection screen. I don't wanna buy a remote with it because I want to control it with Domoticz, but how do I manually program it?

Can somebody tell me which settings it requires?

• Switch Type
• Type
• House COde
• Unit Code

Kind regards,
David