Here is an update...

I have started from scratch - new OS install, new Domoticz install and reset to factory settings of my Z-Stick.
After adjusting the file manufacturer_specific.xml, adding ZME_05434.xml (the xml file for Z-WAVE>ME ZMEE05434 which I created myself) and removing the zwcfg*.xml ...

Back again,

I have restarted from scratch.
Started with an image file "domoticz-raspberrypi-sdcard-4834.img". This has kernel 4.1.18-v7+ #846.
Used the PIco installer script created by Siewert https://github.com/Siewert308SW/pico_installer .
The install ran successful, but after reboot I got ...

Back again,

I have restarted from scratch.
Started with an image file "domoticz-raspberrypi-sdcard-4834.img". This has kernel 4.1.18-v7+ #846.
Used the PIco installer script created by Siewert https://github.com/Siewert308SW/pico_installer .
The install ran successful, but after reboot I got an ...

Hi there,

I am relatively new to the Raspberry Pi and Domoticz and I am following your post on how to install the UPS PIco HV3.0A Top End on my Raspberry Pi 3 in combination with Domoticz.

I have found that at first when I check if i2c is running with the command below I didn't get a response ...

Here is an update...

With the help of ZWAVE>Me I found out that I have bought the product with code ZMEE05434.
I adjusted the manufacturer_specific.xml and added a line under manufacturer Popp/Duwi:

<Manufacturer id="0064" name="Popp / Duwi">
<Product type="1000" id="0009" name="Wall Insert ...

Hi,

I am relatively new to Domoticz.
Recently I bought a Z-WAVE>ME Secure Z-wave Wall Insert Switch (2-Wire) because I have a situation where I don't have a neutral wire.
Domoticz is recognizing the device as 'Popp / Duwi Wall Dimmer Set for Busch-Jaeger DURO 2000', but the device is not reacting ...