After some more trying; 2020-01-13 18:13:43.960 OpenZWave: Value_Added: Node: 2 (0x02), CommandClass: SWITCH BINARY, Label: Switch, Instance: 1, Index: 0 2020-01-13 18:13:43.963 OpenZWave: Value_Added: Node: 2 (0x02), CommandClass: SWITCH MULTILEVEL, Label: Step Size, Instance: 1, Index: 6 2020-01 ...

I think if you scroll four posts down, see you will see my post about probably the same modules. Are you using the "ZMNHCDx" modules too?

Hi Lost, thank you very much for your reply! I indeed tried this; remove (exclude the module), replaced the configuration file for ZMNHCDx.xml + remove the cache config file, reboot and thén re-included the module. Still I just have one 'level' switch when the hardware is added under 'devices' page ...

Hi All! I have 2x ZMNHCDx modules here and want to use them to control my shutters on the outside of the house. When adding new hardware I only get one 'level' switch added, this controls the "Q2" connector, but I cannot control the Q1 feed. It simply is not added. What I have tried; - exclude ...

I hope it is fine to ask this, if not please let me know. I have been looking for an Eneco Toon for some time now. What I want is to use it as thermostat but show on the display a webbrowser. Anybody knows if this is possible? It is running Linux I think?