Just bumping this. If anyone has ANY information about making the Thermopro devices working with Rfxcom I'd greatly appreciate it.

br

Hi I've been trying to make the Rfxcom work with my BBQ thermometer, a Thermopro 20, but no luck. Anyone know if this is possible? I know that someone has made this (https://github.com/merbanan/rtl_433/releases) work with it, so maybe there is hope that this too could get into a future update of ...

Hi
Whenever I enable MyDomoticz in settings, my Domoticz installation (RPi3) inevitable crashes after a few hours. This has been the case since I started trying MyDomoticz a number of weeks ago. Just wondering if anyone else is experiencing the same?

br

Hi, I'm relative new to the world of Domoticz and I've just discovered Dashticz. A general question is, does the architecture of Domoticz allow for sending server notifications to it's clients or do they have to poll the server for changes? I just tested very simple Dashticz installation yesterday ...

Solved!

Apparently, four times is the charm for zwave. Rebooted, excluded and included and now it works. Go figure.

br J

Hi I have six Vision EU 2102 door/window sensors. I had them included to the ZWave.Me Raspberry GPIO board using the ZWay software. (RPi 3) When switching to Domoticz 3.6953 I excluded one of them and then included it again. (I've done this three times with identical results) The device gets ...

Hi, Sigma Design has releases an open specification (http://zwavepublic.com/developer) and reference implementation of a Z/IP gateway. I was wondering if this changes anything in regards to Domoticz future implementation of z-wave hw interaction? I haven't read all of it yet, but as I see it this ...