Not sure it's the most optimal, but this appears to work...

Create an Actual switch for the device, e.g. "RealSwitch"
Create a Virtual Switch called "Switch"

Create a LUA event script for the device, programming the required logic into the script, and call RealSwitch = ON / OFF from the virtual ...

This is now fixed, and the Louvolite One-Touch blind is working very well from Domoticz, including Timers although they are somewhat confusing for blinds. More on that later.

The solution was as follows:

1) Shutdown Domoticz and disconnect the RFXCom
2) Connect RFXCom to a windows PC
3) Using ...

Here is the output from RFXmngr

Down (Close) - Stop - Up (Open) commands sent from the handset on channel 1

------------------------------------------------
Packettype = BLINDS1
subtype = Safy / RollerTrol / Hasta new
Sequence nbr = 4
id2-3 = A2A6
Unit = 1
Command = Close
Signal level = 8 -56dBm ...

Hi,

Having some difficulties adding a Louvolite blind.

RFXCom433e with 1005 firmwares. I have to install the Type2 firmware in order to sniff the protocol, this shows up as
BLINDS1 - Safy/Hasta New/RollerTrol
ID2-3 is A2A6
Unit ID is 1

From RFXMngr in Windows it works fully, open, stop and close ...

I guess this might also be used for heating / lighting purposes. e.g. shutting down the boiler when a window/door sensor opens.

Any direction or assistance greatly appreciated

Hi all,

New to Domoticz, but have run a Raspberry PI v2 for 2+ years linked with LightwaveRF and home-brew/adapted PHP, Python and Ruby scripts controlling various aspects.

I'm actively looking at switching to Domoticz, and have invested in a Raspberry Pi v3 and RFXCom433E.

So far, got it ...