[683] Mark device as dead when node is dead
Posted: Sunday 10 January 2016 9:44
Sometimes a zwave node is marked as dead. This info isn't available in the switch status in the GUI nor in JSON API.
You only notice that after trying to switch that device.
It could be a good idea to change the status of a device from On/Off to Dead when the parent zwave node is marked as dead.
With that info a red cross can be shown on the switch.
You only notice that after trying to switch that device.
It could be a good idea to change the status of a device from On/Off to Dead when the parent zwave node is marked as dead.
With that info a red cross can be shown on the switch.