Working in Windows 10 OS, not on a Synology DS214+

[Eternity]

Partially solved!

After a re-boot of my Synology, both the Multisensor and the PIR were added.
After another boot, the Multisensor was available in the devices. Great!

The PIR is "asleep"... and that seems to be a common problem with this brand.

I am running Domoticz v2.3815 as a package on my Synology DS214+

The front USB port is used to connect a "Aeotec Z-Stick Gen 5Z" controller.
A Greenwave Powernode is recognized without any problems
I tried adding a "Vision ZP3102 EU PIR Motion Sensor", and it showed up, but was always "asleep". It didn't seem to see any motions...
My "Aeotec Multisensor 6" is not found at all...

I installed Domoticz on my Windows 10 system (v2.3799), installed drivers for controller and within a few seconds all z-wave stuff was recognized!

So, the hardware seems to work on a Windows system not in Synology package

[jumbotroll]

Is the Windows 10 and the Synology NAS placed at the same location?
Maybe a out of range problem?
viewtopic.php?f=4&t=5958

Regards
Jumbotroll