Domoticz

Hello everyone,
The flap closure opener switch works randomly using Domoticz .
I diagnosed the problem, just the time to send the radio signal, which is unfortunately too short.
Do you know the code page was modified to increase this time ?
For information;
With the remote Blyss must be a 2s pulse on the push button so that all components closes and opens properly.
Thank you for your answer.
Greetings

Following the b_weijenberg message, I reported the problem to RFXCOM . Thank you

After many test I confirm that your new firmware 094 works very well . he resolut several problem , opening closed but also sends a command to stop during opening and fermteure .