Domoticz

Hello,

Has anybody successfully implemented the Mertik G6R-H4S1 remote using RFXtrx433E (with the current firmware - Version 248). If I enable the Mertik protocol, with undec also, then nothing is received. However, if I enable Visonic then I get the following data:

OFF:
------------------------------------------------
Packettype = UNDECODED RF Message
UNDECODED VISONIC:09FC00
------------------------------------------------
Packettype = UNDECODED RF Message
UNDECODED VISONIC:0C3F80

UP:
------------------------------------------------
Packettype = UNDECODED RF Message
UNDECODED VISONIC:09FA00
------------------------------------------------
Packettype = UNDECODED RF Message
UNDECODED VISONIC:0C3F40

DOWN:
------------------------------------------------
Packettype = UNDECODED RF Message
UNDECODED VISONIC:09F900
------------------------------------------------
Packettype = UNDECODED RF Message
UNDECODED VISONIC:0C3F20


ON (achieved by pressing 'OFF' and 'UP' simultaneously):
------------------------------------------------
Packettype = UNDECODED RF Message
UNDECODED VISONIC:09FE00
------------------------------------------------
Packettype = UNDECODED RF Message
UNDECODED VISONIC:0C3FC0

-------------------------------------------------------

Any assistance with adding this control to my Domoticz system would be much appreciated.

Thanks for reading.