Page 1 of 1
Moving Danfoss Living Connect from Utility to Temperature
Posted: Saturday 21 November 2015 12:01
by garethhowell
For some reason, the Danfoss 014G0013 I've just added has appeared on the Utility tab whereas I would have thought it would appear on the Temperature tab. Can I change this?
Gareth
Re: Moving Danfoss Living Connect from Utility to Temperatur
Posted: Saturday 21 November 2015 12:18
by zofiel
no, It's correct. Danfos Lc13 is not a sensor, It's added as setpoint device, so It have to be in utility tab.
Re: Moving Danfoss Living Connect from Utility to Temperatur
Posted: Saturday 21 November 2015 18:38
by garethhowell
Thanks.
As a newbie that would suggest that the term "Utility" needs to be reviewed. To me, utilities means mains ac, gas etc.
Gareth