Domoticz

Hello,
I want to switch my domoticz installation from raspberry to synology but I have some X10 devices.
How I can install mochad (or another) inside the synology to use X10 protocol.
I don't want to use chroot to do this.

Thanks

Maybe you can use the following link from a Dutch Synology forum
http://www.synology-forum.nl/algemeen/x ... -synology/.

@pipitch: did you get it working?
I'm struggeling, on my Pi mochad workes fine, on my synology not.. and forwarding the switches works most of the time, but sometimes the status is displayed wrong on my synology... so that's why I would love to get mochad up and running on my synology

Yes and No. I use synology for all except x10. For the X10, I send the command to a raspberry (mochad is installed on rapsberry)
It's not the best way, but I will change my x10 device by zwave device.

hmmm, than I just keep trying... since I have my entire house with x10 power line devices, since getting them in sync all the time will also be a lot of work.

I will let you know when I get it up and running!

Maybe I can cross compile the mchad binary into my domoticz package for synology, is that helping?

if that's possible, would be great!
it would also need libusb 1.0 or higher to work

franzelare wrote:if that's possible, would be great!
it would also need libusb 1.0 or higher to work

Libusb 1.0 is included in domoticz package also.
I can compile a test for you.
What NAS do you have and DSM version?

I have a synology DS114 running on DSM 5.2-5644 Update 5
is that enough?

Deleted, see next post.

Edit:
Packages deleted.
The package is reported not working

I have a MARVELL Armada 370
which package should I install?

Edit.
Deleted

first time I will install a beta package.
I should stop domoticz, manually install this package?

franzelare wrote:first time I will install a beta package.
I should stop domoticz, manually install this package?

Take backup of db and reinstall if you have a very old version.

Edit:
The package is reported not working.

hmm, i was planning to give it a try today, if you have an other revision, or have an idea how to get rid of my message:
configure: error: C compiler cannot create executables

franzelare wrote:hmm, i was planning to give it a try today, if you have an other revision, or have an idea how to get rid of my message:
configure: error: C compiler cannot create executables

I have build standalone packages for mochad and netcat you can test.
You must install both packages.

http://www.jadahl.com/synology/?arch=armada370

from the command line or from the package center?

franzelare wrote:from the command line or from the package center?

Package center
I don't build bootstrap packages.