Domoticz

Hello everybody,

I can't configure my Siren Everspring SE812 to my Domoticz on a raspberry PI with domoticz.
I see them on my controller but the config info don't come to my domoticz.

Any idea ?

regards,
Vince

Any Idea ?

Hi,

I have exactly the same issue. I see them on my controller but the config info don't come to my domoticz and i see se812.xml file under config. Please do you resolve your problem?
Futhermore i can't see any device in tab device attach to my siren. i think it's because he don't find config file?

I join a screenshot to explain my problem.

Thanks a lot

push the button many time..
So he wakeup...

Hi,

I push the button several time on the siren but unfortunetly the configuration on domoticz doesn't display. Have you this problem too?

Thanks a lot
Kind Regards

Hi!
I've got a similar trouble.
After a couple of hours, the little green check mark at the end of the line becomes a red exclamation point.
Then, i can not send any command anymore to the siren.
When I reboot the siren (removing the batteries), i can see it healthy again in domoticz... but only for a while
An idea ?
Thanks a lot.
Kind Regards.
mamouth