Control A-OK Motor with RFXcom433XL
Posted: Friday 23 October 2026 16:05
Hello,
I would like to control an A-OK motor using an AC123 remote control. I have an RFXcom433XL with the Pro XL1 firmware. In RFXmanager, my remote is detected as type: "Blinds1" and subtype: "T3 A-OK AC114." I have paired the motor using RFXmanager, and everything works correctly—I can operate the shutter without any issues.
However, when I try to add this remote manually in Domoticz, I select the type "Blinds," but "T3 A-OK AC114" is not available in the subtype list. If I add it via "auto-detection" , switchtype is blank but Domoticz does create a device, but I am unable to control the shutter; nothing works. Does anyone have any ideas?
Thank you.
I would like to control an A-OK motor using an AC123 remote control. I have an RFXcom433XL with the Pro XL1 firmware. In RFXmanager, my remote is detected as type: "Blinds1" and subtype: "T3 A-OK AC114." I have paired the motor using RFXmanager, and everything works correctly—I can operate the shutter without any issues.
However, when I try to add this remote manually in Domoticz, I select the type "Blinds," but "T3 A-OK AC114" is not available in the subtype list. If I add it via "auto-detection" , switchtype is blank but Domoticz does create a device, but I am unable to control the shutter; nothing works. Does anyone have any ideas?
Thank you.
- rfx1.jpg (150.95 KiB) Viewed 32 times
- rfx2.jpg (107.17 KiB) Viewed 32 times