Domoticz

Hi,
Anybody got a clue why the heater in the heater in the garage is not turning on?
Today all three conditions were met; temp below 8 degrees, solarpanels producing more than 1000 watts and heater was off.

What is the trigger for the script? Should be device or time or All (not preferred).

It seems you need the if-then block (without the blue gearwheel).
You used the else-if block....

WilcoEHV wrote: ↑Friday 10 January 2025 19:47 Hi,
Anybody got a clue why the heater in the heater in the garage is not turning on?
Today all three conditions were met; temp below 8 degrees, solarpanels producing more than 1000 watts and heater was off.

Schermafbeelding 2025-01-10 194254.png

Your script tests for actuals > 1000 kWh while your mail mentions > 1000 Watts?
Which unit does your sensor show? Factor 1000?

Hi,
Thx for the replies!
I changed the if then block to one without gearwheel.
Hopefully this works!!

Triggers are in the script.
Solaredge reports watts and kwh (although i named it kWh).
I've got it on a different system where it's responding to watts.

Hi,
An update; the script is running as expected by now!
Thx for the help.