Page 1 of 1

Thermostat State

Posted: Thursday 24 August 2023 8:29
by sivaci2754
I have Honeywell and 2Gig Z-Wave Plus thermostats. When the setpoint is triggered and heating is engaged, the state indicator which is id 66, turns to 1.

zwave-js-ui will publish that to mqtt. But with the auto-discovery in domoticz, i have a) measured temp, b) setpoint temp, c) mode setting.

But I don't see anything in the event log, or anything indicated.

Is the state available somewhere in Domoticz?

Re: Thermostat State

Posted: Thursday 24 August 2023 16:50
by waltervl
It could be that it became a number device and then it is in the setup section of the MQTT AD hardware gateway
https://www.domoticz.com/wiki/MQTT#MQTT ... very_Setup