I have an old mechanical ventilation that is starting to make noise and I would like to replace. It still has the old perilex plug but I rather switch to a remote control protocol.
Anyone aware of a box that supports wifi and can be controlled from domoticz? The only alternative I see is an ITHO box with rfxcom/868 but then I need to buy another interface (rfx868) .
I did some googling but struggle to find an obvious solution. Thx for any help!
Docker in Truenas scale, close to latest beta
DASHTICZ 🙃
RFXCOM, zwavejs2mqtt, zigbee2mqtt,
P1 meter & solar panel
Google home, Wifi Cams motion detection
Geofence iCloud, Bluetooth & Wifi ping
Harmony hub, Nest, lots more :-)
I left the perliex plug original and made it switchable with a 3 port rfcom switch. You can of course use a different kind of remote switch like zwave.
Hi,
you don't need a ventilation system with WiFi.
My ventilation system ( EMMETI RECUPERADRY ) has a controller with some inputs that can be connected to a domotic relay module, to enable/disable
air renew
Dehumidifer (chiller)
hot/cold water exchanger
.....
Maybe all VMC has such inputs.
an_creDomBus31_pdc_vmc.jpg (169.94 KiB) Viewed 1900 times
I left the perliex plug original and made it switchable with a 3 port rfcom switch. You can of course use a different kind of remote switch like zwave.
That's something I have done for my current setup. I was just hoping that there are Wifi controllable ventilation units by now that would make that easier. Doesn't look to be the case.
Docker in Truenas scale, close to latest beta
DASHTICZ 🙃
RFXCOM, zwavejs2mqtt, zigbee2mqtt,
P1 meter & solar panel
Google home, Wifi Cams motion detection
Geofence iCloud, Bluetooth & Wifi ping
Harmony hub, Nest, lots more :-)
I think there’s but they are much expensive then this solution and you have the choice how to controle them by zwave,rf or zigbee,
I have left the original cable in tact from the litho ventilation system see photo
rron wrote: ↑Friday 03 March 2023 12:32
I think there’s but they are much expensive then this solution and you have the choice how to controle them by zwave,rf or zigbee,
I have left the original cable in tact from the litho ventilation system see photo
I've the same configuration with a fibaro switch 2
Then you can control the ventilator in 3 speeds. : On/low/High
An advantage is a rron says, you can keep the perilex connection to original
-= HP server GEN8 Xeon(R) E3-1220L_V2 -=- OZW -=- Toon2 (rooted) -=- Domoticz v2024.7 -=- Dashticz v3.12b on Tab8" =-
One RPi with Domoticz, RFX433e, aeon labs z-wave plus stick GEN5, ha-bridge 5.4.0 for Alexa, Philips Hue Bridge, Pimoroni Automation Hat
One RPi with Pi foundation standard touch screen to display Dashticz
Docker in Truenas scale, close to latest beta
DASHTICZ 🙃
RFXCOM, zwavejs2mqtt, zigbee2mqtt,
P1 meter & solar panel
Google home, Wifi Cams motion detection
Geofence iCloud, Bluetooth & Wifi ping
Harmony hub, Nest, lots more :-)