Reading setpoints
Posted: Sunday 19 February 2023 0:34
Hi,
I use a SSM-D2 to interface with my Evohome system. The SSM-D2 implements the same Ramses protocol as the HGI80. One Ramses command is apparently not implemented in Domoticz: the Zone Schedule command (#0404, see https://github.com/zxdavb/ramses_protoc ... e-Schedule). Being able to read the schedule would make temporary overriding multiple setpoints possible. At this moment it's only possible to override until the next scheduled setpoint, but not until a next setpoint after the next one.
It would be great if the #0404 command would be implemented in Domoticz. How can I make a request for that?
Peter
I use a SSM-D2 to interface with my Evohome system. The SSM-D2 implements the same Ramses protocol as the HGI80. One Ramses command is apparently not implemented in Domoticz: the Zone Schedule command (#0404, see https://github.com/zxdavb/ramses_protoc ... e-Schedule). Being able to read the schedule would make temporary overriding multiple setpoints possible. At this moment it's only possible to override until the next scheduled setpoint, but not until a next setpoint after the next one.
It would be great if the #0404 command would be implemented in Domoticz. How can I make a request for that?
Peter