Domoticz

Hi there,

I bought some new Neo Coolcam Pir's, although they look exactly like the model PDZ-02, they have a different hardware.
They are not recognized and give ID=1036, tried to use the nas-pd02z.xml in manufactor_specific.xml but that does not work.
I see that they have motion, lux, temp & humidity now, humidity is a new feature.

BTW this is not the 7z series, got those finally operational.

I hope there is an XML file out there.

Raspberry 4
Aeotec Z-stick ZW-090Z
Domoticz 2022-2

I used nas-pd03z.xml and changed the id from 1031 to 1036.
Updating the parameters doesn't work but i edited the file and changed the default values to the values i want.
It sort of works, values differ from my older pirs (lux level much lower) but at least i can use it as a motion sensor.
Neo coolcam answered me this version is updated to zwave 700.
I asked them to send me an up to date xml.

Perhaps you can check here: https://community.openhab.org/t/neo-coo ... /139255/14

I also asked Coolcam for an updated XML but they told me that they don't have that.
It was also mentioned that this is the Z-Wave 700 chip.
In the mean time I have 3 of them and can't really configure them.

Wish somebody could create a working XML for this device.
There is also a temperature and humidity sensor in this one.

@walterevl I saw that link already, but it is about Open Hab and the XML file is not for Domoticz.

This XML sort of works

This XML is not working either, you can't config the parameters.
I hope it will work sooner or later in the new Z-wave zwave2mqtt.
This is a new device with more functionality, I would think it is already used somewhere.

Open the file and edit the value to what you want it to be.