Error: RFLink: Error opening serial port after upgrade to 2020.2
Posted: Monday 20 June 2022 11:14
Hi
I run domoticz on a Synology DS216play nas. (no docker)
I was running 2020.1 for quite some time now without issues. I noticed the latest version for my NAS is 2020.2 so I decided to upgrade.
However, since the upgrade I have issues with my USB RFlink antenna. It is working fine but when I do a reboot of the NAS, domoticz doens't restore the connection with the RFlink. I have the following error in the log:
Error: RFLink: Error opening serial port!
Status: RFLink: serial retrying in 30 seconds...
When I simply replug(in the same port) the RFLink starts working fine again.
I already followed this doc: https://www.domoticz.com/wiki/PersistentUSBDevices
But unfortunately, it is not helping.
Hoping to find a solution here.
Thanks
I run domoticz on a Synology DS216play nas. (no docker)
I was running 2020.1 for quite some time now without issues. I noticed the latest version for my NAS is 2020.2 so I decided to upgrade.
However, since the upgrade I have issues with my USB RFlink antenna. It is working fine but when I do a reboot of the NAS, domoticz doens't restore the connection with the RFlink. I have the following error in the log:
Error: RFLink: Error opening serial port!
Status: RFLink: serial retrying in 30 seconds...
When I simply replug(in the same port) the RFLink starts working fine again.
I already followed this doc: https://www.domoticz.com/wiki/PersistentUSBDevices
But unfortunately, it is not helping.
Hoping to find a solution here.
Thanks