X2D CPL UART Adaptor
Posted: Sunday 03 April 2022 20:18
Hello,
If you wish to drive your Deltadore or Ecotherm Heaters with the X2D PLC (or X2D CPL), I programmed a small interface that allow to easily send commands thru a serial line (UART 9600 bauds). The serial commands are converted and sent directly to the power line.
Available commands :
Heating commands (« Z1, Moon ») - 9 possible zones, 6 levels (Moon, Sun, etc...)
receiver association (« Z1, Assoc, d=1 ») 6 load shedding channels (d=1 to 6; 0= disable)
Associate a the adaptor to the existing installation like Driver230 CPL, or other.
The usage of UART allow easy interfacing with Domoticz or other automation boxes.
Regards,
If you wish to drive your Deltadore or Ecotherm Heaters with the X2D PLC (or X2D CPL), I programmed a small interface that allow to easily send commands thru a serial line (UART 9600 bauds). The serial commands are converted and sent directly to the power line.
Available commands :
Heating commands (« Z1, Moon ») - 9 possible zones, 6 levels (Moon, Sun, etc...)
receiver association (« Z1, Assoc, d=1 ») 6 load shedding channels (d=1 to 6; 0= disable)
Associate a the adaptor to the existing installation like Driver230 CPL, or other.
The usage of UART allow easy interfacing with Domoticz or other automation boxes.
- Domoticz.png (21.76 KiB) Viewed 305 times