Domoticz

Hi everyone,

I have flashed a shelly Dimmer 2 with Tasmota and Stm32, and did all the parameters from blakadder. It's working fine with Domoticz.

But the dimmer is not working corectly:

I can, from the web managing page, increase and decrease the dimmer (also from domoticz), but at a certain level, like 70% (80 watts), when I decrease the slider to 1%, the light decrease to something like 65%!

In the console, I can see the dimming level at 1, but the consumption on the main page is at 73 watts.

I can only reach low dimming when I toggle on and off. It does like a reset of the dimmer. So at 1%, I have 1 or 2 watts, as normal.

I tried to find a solution on the web, but I found nothing...

Does somebody could help!!!...

Thanks,

Jimmy