Enable temperaturer on a ZMNHOD1 Flush Shutter DC+
Posted: Wednesday 25 August 2021 12:17
Hello,
I have a ZMNHOD1 Flush Shutter DC+ and connected a temperaturer sensor to it but Domoticz don't show it as a temperaturer device.
Any advice what I need to do ?
I have a ZMNHOD1 Flush Shutter DC+ and connected a temperaturer sensor to it but Domoticz don't show it as a temperaturer device.
Any advice what I need to do ?
Code: Select all
110. Temperature sensor offset settings: 32536 (actual: 32536)
From 1 to 100 - value from 0.1 C to 10.0 C is added to actual measured temperature. From 1001 to 1100 - value from -0.1 C to -10.0 C is subtracted to actual measured temperature.
120. Digital temperature sensor reporting: 5 (actual: 5)
If digital temperature sensor is connected, module reports measured temperature on temperature change defined by this parameter. Available settings: 0 - Reporting disabled.
1 - 127 = 0,1C - 12,7C, step is 0,1C.
Code: Select all
Version: 2021.1 (build 13437)
Build Hash: 9ab1f2c32
Compile Date: 2021-08-22 09:32:47
dzVents Version: 3.1.8
Python Version: 3.7.3 (default, Jan 22 2021, 20:04:44) [GCC 8.3.0]