Voltage reading on the analog input of Denkovi DAEnet IP
Posted: Wednesday 04 August 2021 17:28
Hello
I am using a Denkovi DAEnet IP 3 controller to read the DC voltage on one of its analog inputs and to monitor it I have it connected to Domoticz.
But Domoticz only shows me the whole part of the voltage and not the decimals.
I attach screenshots of two samples
What can I do to make Domoticz read the full value?
Regards
I am using a Denkovi DAEnet IP 3 controller to read the DC voltage on one of its analog inputs and to monitor it I have it connected to Domoticz.
But Domoticz only shows me the whole part of the voltage and not the decimals.
I attach screenshots of two samples
What can I do to make Domoticz read the full value?
Regards