Just do it yourself, very easyvoorzien van flexibele draadantenne

Moderator: leecollings
Just do it yourself, very easyvoorzien van flexibele draadantenne
I have this one, it's fairly obvious where the antenna is at:ThinkPad wrote:Yes.
Just do it yourself, very easyvoorzien van flexibele draadantenne5 min work.
I couldn't agree moreHeisenberg wrote:Although all the tips are great regarding modding devices by extending the antenna wire I'm still looking for an aesthetic solution for the RFXcom433(E). Because then you only have to mod the RFXcom433 instead of all the devices that don't receive signals properply .
ThinkPad wrote:
I bought this antenna: http://www.ebay.com/itm/281126334307 and pulled the plastic off.
Then desoldered the standard coil, and attached a 17cm stiff wire of a networkcable to it like this: Drilled a small hole in the top of the plastic tube so the wire can go through it, pressed the plastic tube back on to the connector and ta-da! Works fine and will cost you little.
That picture comes from me. I now have a vector impedance analyzer and measured several antennas.ThinkPad wrote: ↑Thursday 04 June 2015 8:59 The original antenna seems to be quite small actually, someone discovered: http://domoticz.com/forum/viewtopic.php?f=44&t=6772
So it is not a miracle that a other/longer one is working better.
![]()
Users browsing this forum: No registered users and 0 guests