Domoticz

Not sure how to do this or to request it. The parameter 151 to select a Auto or Delay mode is missing;

151 - Second Channel - Operating Mode

This parameter allows to choose operating mode for channel controlled with Q2 output. For timed modes (value 1, 2 or 3), time is set with parameter 155 and reaction to input change is set with parameter 153.

Parameter size: 1B
Default value: 0 (standard operation)

Available values:

0 – standard operation

1 – delayed OFF

2 – auto OFF

3 – flashing

How to add it?

Many thanks in advance for anyway guiding me to a solution,

Regards.

Fred.

Hi,

when i change parameter 150 to 2 and 154 to 10 for example, Q1 is set to momentary with 1s ON. when I try to change with same value on Q2 (parameter 151 and 155) , Q2 is always set as standard mode.

And also if Q1 and Q2 are set in standard operation , lock enabled works well but if i change Q1 to auto OFF, lock doesn't works, curious because i want to avoid 2 outputs ON in same time and even if Q1 is auto OFF, Q1 is momentary ON and if Q2 is ON ... problems

is it a limitation ? a problem of configuration ? an evolution to make on this module ?

Best regards


onevanilla