Domoticz

Hi all,

I am currently experiencing a strange phenomenon. When I enable or disable 1 of the Fiber Wall plugs, these are always 3 actions. I see 3 switching actions in the logging. See below:
2020-12-16 10:18:16 On Open Z-wave
2020-12-16 10:18:15 Off Open Z-wave
2020-12-16 10:18:15 On Admin
2020-12-16 10:18:12 Off Open Z-wave
2020-12-16 10:18:12 On Open Z-wave
2020-12-16 10:18:11 Off Admin
2020-12-16 10:17:26 On Open Z-wave
2020-12-16 10:17:26 Off Open Z-wave
2020-12-16 10:17:26 On Admin
2020-12-16 10:17:23 Off Open Z-wave
2020-12-16 10:17:23 On Open Z-wave
2020-12-16 10:17:22 Off Admin
2020-12-16 10:12:27 On Open Z-wave
2020-12-16 10:12:27 Off Open Z-wave
2020-12-16 10:12:27 On Admin
2020-12-16 10:12:22 Off Open Z-wave
2020-12-16 10:12:22 On Open Z-wave
2020-12-16 10:12:22 Off Admin

The Admin one is an action by me on the screen, but then Open Z-wave toggled the wall plug again.
Very strange.

The only thing I can imagine is that there is still something active with Master / slave settings in the background. I played with that, but put everything back and deleted/cleared it.
I have 4 Fibaro Wall plugs and with 3 of them I have done some testing with the master/slave function and this resulted in the above problem.
The 4th one I did not edit and works fine.

Can anyone help me explain what is happening here?

Kind regards,
Frank