How to add a rain sensor ?
Posted: Sunday 08 November 2020 13:50
My rain sensor also contains a temp sensor, when added to Domoticz the temp is fine but the rain level shows up as a humidity value and i can't figure out how to get it to be seen correctly, any ideas anyone?
The label on the bottom says:
R-NZ
Aercus Instruments
Freq 433Mhz
Model KW9015
Batch 160915
Its one of those that has a little see saw type arrangement inside that rocks back and forth as the cups on the end fill with water.
My RFXCom see it as a "SubType" Alecto device
TIA
Dave
The label on the bottom says:
R-NZ
Aercus Instruments
Freq 433Mhz
Model KW9015
Batch 160915
Its one of those that has a little see saw type arrangement inside that rocks back and forth as the cups on the end fill with water.
My RFXCom see it as a "SubType" Alecto device
TIA
Dave