Domoticz

Hi all,

I just installed a Daikin (FTXM50N / 2020) with a WiFi controller. After networking, I have normal operation of the Daiking app on the smartphone.

Following the wiki https://www.domoticz.com/wiki/Daikin_wifi:
- In the hardware configuration, I add "Daikin Airconditioning with LAN (HTTP) Interface"
- I set the IP address, the port (80), login and password and I add the equipment to the list ....

BUT .... I don't see the 3 new devices appearing (the inside temperature, the outside temperature and the target temperature).

Did I miss something?

Best regards
Philippe
-----
Domoticz 2020.2 / Raspberry Pi 3 / Linux 10 (buster) / Dzvents 3.0.2 / Python 3.7.3

Without doing anything, now I have 2 devices: "Outside temperature" and "Home temperature" but still not "Target temperature" .... strange

Hello

i had the same issue
i had to wait a moment to see 8 new devices

Hi,

From where did you get the login and password?
I dont remember having been afsked to define that anywhere.
Only for my daikin online account. Is it this?

Br
Ar