Domoticz

Hi,

I was looking for "zigbee temperature sensors" on AliExpress and found 2 different from xiaomi. I thought the round one was better looking.

Now I just noticed on a YouTube video the round mija is a Bluetooth device and the square aqara is zigbee.

What does it take to get the Bluetooth low energy sensor to work on domoticz?

From what I have seen so far is a cc2540 sniffer that might work the same as a cc2531 only for Bluetooth.

Any help please

Contact the seller at Ali

Hi,

See: - https://www.domoticz.com/forum/viewtopic.php?t=21904

Maybe this is a solution to use them.

Regards

HvdW wrote: Tuesday 11 August 2020 13:29 Contact the seller at Ali

Won't help, I found out after they were shipped

FireWizard wrote: Tuesday 11 August 2020 13:33 Hi,

See: - https://www.domoticz.com/forum/viewtopic.php?t=21904

Maybe this is a solution to use them.

Regards

Thank you, I'll check it out when I get them.

Why not using DomBusTH calibrated temperature + humidity sensors?
No RF pollution, 4 inputs and 2 outputs included, 3 LEDs for status notifications, everything connected by a 4 wire cable, 2 for data and 2 for 12V power supply, so the system works also in case of blackout!
https://www.creasol.it/CreasolDomBusTH

psubiaco wrote: Wednesday 12 August 2020 9:58 Why not using DomBusTH calibrated temperature + humidity sensors?
No RF pollution, 4 inputs and 2 outputs included, 3 LEDs for status notifications, everything connected by a 4 wire cable, 2 for data and 2 for 12V power supply, so the system works also in case of blackout!
https://www.creasol.it/CreasolDomBusTH

I do like the functionality though I don't want to install new wiring all around the place.