Page 1 of 1

blockly for roller shutter

Posted: Wednesday 24 June 2020 14:19
by therealman
Hallo friend, sorry for my english... I have domoticz and sonoff dual and 4chpro to control roller shutter. I try to create an event to close partially by given 2 command to releè within few second but not work... what i wrong?
here my event
here my event
roller.gif (21.71 KiB) Viewed 835 times
here my event
here my event
roller.gif (21.71 KiB) Viewed 835 times

Re: blockly for roller shutter

Posted: Tuesday 14 July 2020 20:03
by har0543
did you try on for 4 seconds?
How is the shutter connected in Domoticz?

Re: blockly for roller shutter

Posted: Wednesday 15 July 2020 13:48
by therealman
ciao har0543 thank you for the answer! the 2 shutters are connect to domoticz by a sonoff 4ch pro R2 with the latest espurna fw. I tried for 4 seconds, and less but no work... so the sonoff seem no receive the 2' impuls to stop before the seconds pulse time set on sonoff switch.

Re: blockly for roller shutter

Posted: Sunday 19 July 2020 21:04
by wouterlet
Are you sure on is the right commando? Isn't it stop? When you want to stop it? How does it work when you do it manually?

Re: blockly for roller shutter

Posted: Friday 24 July 2020 11:49
by therealman
Yes, "on" is the right command , exemple: when I use rf remote controller by rfbridge: I push 1 time to open the roller, and another time on after 3 seconds for stop it.

Re: blockly for roller shutter

Posted: Friday 24 July 2020 22:21
by wouterlet
Hmm ok. And if you use a dummy momentary switch to activate the the roller.

Then you can try this by activate this once and again after 4 seconds. To make sure all commandos are right.

Re: blockly for roller shutter

Posted: Thursday 06 August 2020 16:09
by therealman
...friend but... a dummy momentary switch it's that i create to control sonoff 4chpro with domoticz... or not?...