Domoticz

Hey guys...an question;

I bought an Fibaro Inplant to attach my keypad to my Domoticz alarmsystem.
When i add the sensor via zwave within Domoticz its emmidiately found between the 'hardware'.
But i can't find it in the list of devices.

Can somebody advise?

I attached 12 volt to the sensor and on the OUTPUT i attached two wires, the two wires i am measuring because i hoped to swicht the Fibaro ON/OFF and see an 12 volts output on the fibaro.

Hopefully somebody can help me!

Thanks

The "output" is potential free, meaning they are just closed or open.
They do not transfer any power from the input