Roller Shutter TZ75 TKB
Posted: Wednesday 03 June 2020 21:51
Hello,
I have installed several roller shutters controller from TKB TZ75 to a Fibaro HC2 hub and I am having problems with some of them.
Most work properly but three of them are not working fine.
When I open roller in the morning, they stop any place but not at the end and I need to switch several times to reach upper part. After that first operation, they work fine.
Has anyone suffer a similar problem?
Could it be that roller is hard to open first time every day and controller stop due to high load?
I also reconfigured them several times, but following day it fails again.
Thanks for your help.
Regards,
Roberto.
I have installed several roller shutters controller from TKB TZ75 to a Fibaro HC2 hub and I am having problems with some of them.
Most work properly but three of them are not working fine.
When I open roller in the morning, they stop any place but not at the end and I need to switch several times to reach upper part. After that first operation, they work fine.
Has anyone suffer a similar problem?
Could it be that roller is hard to open first time every day and controller stop due to high load?
I also reconfigured them several times, but following day it fails again.
Thanks for your help.
Regards,
Roberto.