GPIO switch shown as 'Impuls' devices tab
Posted: Saturday 23 May 2020 23:56
Hi all,
I got 4 GPIO output working on the Raspberry Pi, no problem.
The problem is when i want to use this idx in a scene or Blocky, the switch doesn't response well. It switches on, but not off.
The only thing i see is in under the devices tab is the GPIO output shows impuls. And i can imagine on/off doesn't work if its is a impuls.
is there something i can do about this? i am not into the scripting stuff. A noob
Would love to post a screenshot here, but don't know how...
I got 4 GPIO output working on the Raspberry Pi, no problem.
The problem is when i want to use this idx in a scene or Blocky, the switch doesn't response well. It switches on, but not off.
The only thing i see is in under the devices tab is the GPIO output shows impuls. And i can imagine on/off doesn't work if its is a impuls.
is there something i can do about this? i am not into the scripting stuff. A noob
Would love to post a screenshot here, but don't know how...