Domoticz

Hi,

I have a Z-Wave dimmer. When I switch it on and off in Domoticz, it dims to the corresponding value. On the switch interface, I can see, for instance if I switch it off:
- Immediately after clicking, it goes to the "off" state.
- Shortly after, it goes back to the "on" state, probably because the device is dimming down and reporting to be still on
- And when the bulb finally switches off, the status is reported and goes back to off...

So just switching a light reports On > Off > On > Off instead of On > Off.
If I set an event triggered by this device, it gets triggered three times... How can I avoid this?

Thanks!