OpenzwaveUSB serial port is empty adding new hardware
Posted: Friday 24 April 2020 16:02
Hi all,
Finally I started to set up my new domoticz platform. Currently my domoticz is running under Raspberry Pi (Buster) with a Razzberry to control the Z-wave devices, and now I plan to move it to a NUC Intel based server. I installed a Proxmox 6.1 on debian 10.3 and I created a Container alo debian 10.3.
A domoticz 2020.1 is running in the new platform just with Netatmo devices and dummy sensors. I have a new AEOTEC USB stick Gen5 to control Z-wave network in the new platform, and here comes my problem. When I add the new hardware OpenZWave USB, the serial port pulldown is empty and I can't select ttyAMC0 port. I think everything is ok. I configured host to passthrough USB device to container and I can see /dev/ttyAMC0 (root:dialout) in container file system, so I have no idea what is going on. Any clue about what I have to do to make it works?
Thanks in advance
Finally I started to set up my new domoticz platform. Currently my domoticz is running under Raspberry Pi (Buster) with a Razzberry to control the Z-wave devices, and now I plan to move it to a NUC Intel based server. I installed a Proxmox 6.1 on debian 10.3 and I created a Container alo debian 10.3.
A domoticz 2020.1 is running in the new platform just with Netatmo devices and dummy sensors. I have a new AEOTEC USB stick Gen5 to control Z-wave network in the new platform, and here comes my problem. When I add the new hardware OpenZWave USB, the serial port pulldown is empty and I can't select ttyAMC0 port. I think everything is ok. I configured host to passthrough USB device to container and I can see /dev/ttyAMC0 (root:dialout) in container file system, so I have no idea what is going on. Any clue about what I have to do to make it works?
Thanks in advance