Domoticz

I've done some update into my Node Red and I've added some MQTT messages to domoticz/in and I've noticed that when the message arrives to domoticz/in, the switch (for example) changes state, but domoticz doesn't announce this switch change to domoticz/out, while if I change the switch state directly into domoticz, the change gets announced to domoticz/out
Is this something new from the last update (I haven't seen anything reated to this into the changelog)? Is there a way to go back to the previous behavior?
Thanks!

Hi,

Please see this thread: https://www.domoticz.com/forum/viewtopi ... TT#p241133

Regards

Thanks a lot!