Domoticz

In the Domoticz log I get the following error message everytime someone is using our entrance door:
Error: OpenZWave: Value_Changed: Tried adding value, not succeeded!

The door lock is an IDLock 150. It has been like that since I upgraded the lock to ZWave 1.6. I assumed that it was caused by Domoticz' missing support for Open ZWave 1.6. The other day, however, I upgraded Domoticz 2020.1, which does have Open ZWave 1.6, but the error messages keep coming in the log. I have restarted the lock, but wih no luck.

Any ideas?

You use and IDlock150 how does it show in Domoticz Zwave nodes? Is it correct included?

Indeed it is. No errors, and all the configuration settings are available.
https://www.dropbox.com/s/0tw76s01yil5n ... e.JPG?dl=0

i have an idlock 101 and i have the same problem. i have asked i a couple of other threads here but never any response.

DeVille70 wrote:Indeed it is. No errors, and all the configuration settings are available.
https://www.dropbox.com/s/0tw76s01yil5n ... e.JPG?dl=0

Looks correct to me - i checked the Open Zwave config branche and no changes since Oct 2019 in the XML so no updates since then - has this ever work correct in Open Zwave version 1.4?

The lock works the way it always did, and as far as I can tell all functionality is there. As such, the subject error message is just annoying, It started coming when I upgraded the lock's ZWave module SW to ver 1.6 a few months ago. I ignored it then, awaiting Domoticz to be upgraded with OZW 1.6, which I did yesterday, but it made no difference.