ZStick + Door sensors
Posted: Wednesday 25 March 2020 18:36
Hello dear forum dudes.
I ordered 3 magnetic door sensors, but cannot connect those to Domoticz.
Door sensors: https://www.aliexpress.com/item/32897581223.html
https://products.z-wavealliance.org/pro ... 27/network
Domoticz has been installed on NAS device and other Zwave-products works ok.
Central Controller is Aeotec Z-Stick Gen5.
There is a small switch inside the magnetic sensor. The sensor goes to inclusion mode and the red led flashes to indicate the enrollment state.
But what is the correct order to connect to the door sensor??? Do I have to press the z-Stick button? Do I have to set some special mode in the Domoticz?
I ordered 3 magnetic door sensors, but cannot connect those to Domoticz.
Door sensors: https://www.aliexpress.com/item/32897581223.html
https://products.z-wavealliance.org/pro ... 27/network
Domoticz has been installed on NAS device and other Zwave-products works ok.
Central Controller is Aeotec Z-Stick Gen5.
There is a small switch inside the magnetic sensor. The sensor goes to inclusion mode and the red led flashes to indicate the enrollment state.
But what is the correct order to connect to the door sensor??? Do I have to press the z-Stick button? Do I have to set some special mode in the Domoticz?