Page 1 of 1
Sourcecode for 4.10717 Needed
Posted: Saturday 21 March 2020 0:00
by eriksson25
Hi. I am looking for the sourcecode for the latest stable version. WHY? I want the stable version, but want to add the latest 1wire patches. So was gone compile it, and grabs the sourcecode from
https://github.com/domoticz/domoticz/ar ... 717.tar.gz
BUT... When compiling it says
###########################
-- Compiling Revision #9700
-- ###########################
And ofc after compiling its 9700 that greats me on the homepage.
Anyone, what am I doing wrong?
Re: Sourcecode for 4.10717 Needed
Posted: Saturday 21 March 2020 7:58
by waaren
eriksson25 wrote: ↑Saturday 21 March 2020 0:00
Hi. I am looking for the sourcecode for the latest stable version. WHY? I want the stable version, but want to add the latest 1wire patches.
Please try
this work around
Re: Sourcecode for 4.10717 Needed
Posted: Saturday 21 March 2020 8:48
by eriksson25
waaren wrote: ↑Saturday 21 March 2020 7:58
eriksson25 wrote: ↑Saturday 21 March 2020 0:00
Hi. I am looking for the sourcecode for the latest stable version. WHY? I want the stable version, but want to add the latest 1wire patches.
Please try
this work around
THX, realy dont know why the dubble "cmake" command was needed when they are exactly the same, but on forst try it still repported 9700 but when I run the cmake command again it stated 10717 so all fine. Compiling now. Hope it works with "hotswaping" 1wire folder from dev branch... We will see.
But thx again!
Re: Sourcecode for 4.10717 Needed
Posted: Wednesday 25 March 2020 14:26
by zenodalla
eriksson25 wrote: ↑Saturday 21 March 2020 0:00
Hi. I am looking for the sourcecode for the latest stable version. WHY? I want the stable version, but want to add the latest 1wire patches. So was gone compile it, and grabs the sourcecode from
https://github.com/domoticz/domoticz/ar ... 717.tar.gz
BUT... When compiling it says
###########################
-- Compiling Revision #9700
-- ###########################
And ofc after compiling its 9700 that greats me on the homepage.
Anyone, what am I doing wrong?
Hi, I also want to compile my own ver4.10717 because I'm running OSMC on my rapsberry pi3b+ as it is my "little media center" but I also want to run domoticz. All went fine until last update (2020.1) which need buster which I cannot install (I think).
Would you kindly explain me all steps in order to correctly compile from source? I found this releases archive
https://github.com/domoticz/domoticz/releases. But everytime I try I get some errors. Thank you very much.
Re: Sourcecode for 4.10717 Needed
Posted: Tuesday 31 March 2020 22:34
by Calzor Suzay
I’m in the same boat using OSMC on a Vero4k, I need the old stable binary as well Arm7l.
Don’t have a clue how to compile it.
Where is the previous version???