Domoticz

I connected a BeNext P1 dongle to my Kaifa smart energy meter (Netherlands). Connecting was easy. Devices show up, and I can see the values of electricity and gas in settings and devices:


But then on the other devices tab, they show up with device name and values mixed up.


How do I correct this? Does anyone know?
Is this a z-wave problem, or should I place this question somewhere else on the forum?

I'm on Domoticz V4.11544 on a raspberry pi 3B

I still have this problem and do not know how to solve this. Anyone?

I have almost the same problem.

i can see in the devices list the correct values. when i add the devices from the devices list the utility buttons show up on the utility tab, but incorrect values show up in the utility tab. i updated domoticz to the latest version 2020-04-26 13:47:55 operating on raspbery PI 4 2GB. i did the updates of open zwave. I use the aeotec gen 5 zwave usb stick. and benext p1 smart meter dongle.
the problem needs to be within the transfer of data between the devices list and utility tab, but i can not fix that.

can the programmer help out?