Read P1 Smart Meter
Posted: Sunday 20 October 2019 14:37
Hi,
i have connected my P1 cable to my Raspberry Pi and added the P1 Smart Meter.
I'm receiving data from my electricity meter, but not from my gas meter:
But Domoticz says it has found my gas meter
2019-10-20 14:33:54.462 Status: P1 Smart Meter: Using serial port: /dev/serial/by-id/usb-FTDI_FT232R_USB_UART_A142U47T-if00-port0
2019-10-20 14:33:54.467 Status: P1 Smart Meter: Worker started...
2019-10-20 14:33:55.434 Status: P1 Smart Meter: Found gas meter on M-Bus channel 1
2019-10-20 14:33:55.449 Status: P1 Smart Meter: Meter is pre DSMR 4.0 - using DSMR 2.2 compatibility
as you can see at the picture below, i only have 2 devices
someone knows how i can get my gas meter data into Domoticz?
thank you
i have connected my P1 cable to my Raspberry Pi and added the P1 Smart Meter.
I'm receiving data from my electricity meter, but not from my gas meter:
But Domoticz says it has found my gas meter
2019-10-20 14:33:54.462 Status: P1 Smart Meter: Using serial port: /dev/serial/by-id/usb-FTDI_FT232R_USB_UART_A142U47T-if00-port0
2019-10-20 14:33:54.467 Status: P1 Smart Meter: Worker started...
2019-10-20 14:33:55.434 Status: P1 Smart Meter: Found gas meter on M-Bus channel 1
2019-10-20 14:33:55.449 Status: P1 Smart Meter: Meter is pre DSMR 4.0 - using DSMR 2.2 compatibility
as you can see at the picture below, i only have 2 devices
- 2019-10-20 14_34_38-Domoticz.jpg (119.36 KiB) Viewed 1329 times
thank you