MySensor, controlling valve and external contact from node

[dzjr]

Hello everybody

I made a node to control a water valve, the valve has its own status contact which I use as status signaling in the controller (Domoticz) of the valve,
The contact uses the same child ID as the control of the valve, in MYScontroller I see that this works well, I send the valve open, if the valve is open the status will also be set to 1, so exactly as I want it .

Only within Domoticz does the status of the control change immediately when the button is pressed, and when the valve is open I see the status getting a trigger again, so the berict will certainly come through.

In the Domoticz hardware settings I have already disabled ACT from this child ID.

Does anyone know how I can adjust this so that the status does not change until the valve has actually changed position?

thank you in advance

dzjr