Domoticz

Hello all,

I build an ethernet gateway which seems to work fine, thorugh serial monitor i get no errors.
then when i try to connect a node they don't get an id assigned.
i get the following output. i now use a example sketch from mysensors.

406833 TSM:ID
406834 TSM:ID:REQ
406837 TSF:MSG:SEND,255-255-0-0,s=50,c=3,t=3,pt=0,l=0,sg=0,ft=0,st=OK:
408844 TSM:ID
408845 TSM:ID:REQ
408848 TSF:MSG:SEND,255-255-0-0,s=13,c=3,t=3,pt=0,l=0,sg=0,ft=0,st=OK:
410855 !TSM:ID:FAIL
410856 TSM:FAIL:CNT=7
410858 TSM:FAIL:DIS
410860 TSF:TDI:TSL

Which mysensors network are you using?
For RS485 auto ID is not working for example.

Which network? i'm using an ethernet gateway.

Which network? i'm using an ethernet gateway.

MySensors is a network of nodes connected to Domoticz through the gateway ( ethernet or USB ).
Nodes are connected to gateway via radio ( NRF24 or RFM69 ) or RS485 bus.
Nodes can ask gateway for node ID and gateway will send them unique ID.
But this is not working with RS485bus.
Gateway has always ID=0.
So if you have got only ethernet gateway and sensors connected to it, ID will be 0.
Or you mean sensor ( or child ) ID instead of node ID in your question.